ADM1177-2ARMZ-R7

ANALOG DEVICES  ADM1177-2ARMZ-R7  芯片, 热拔插控制器, 3.15V-16.5V, MSOP-10

The is a Hot Swap Controller and Digital Power Monitor with soft start pin. It offers digital current and voltage monitoring via an on-chip, 12-bit analog-to-digital converter ADC, communicated through an I²C® interface. An internal current sense amplifier measures voltage across the sense resistor in the power path via the VCC pin and the SENSE pin. It limits the current through this resistor by controlling the gate voltage via the GATE pin of an external N-channel FET in the power path. The voltage across the sense resistor and, therefore, the inrush current is kept below a preset maximum. It protects the external FET by limiting the time that the maximum current runs through it. This current limit period is set by the value of the capacitor attached to the TIMER pin. Additionally, the device provides protection from overcurrent events that may occur once the hot swap event is complete.

.

Allows safe board insertion and removal from a live backplane

.

Precision current sense amplifier

.

Precision voltage input 12-bit ADC for current and voltage readback

.

Charge pumped gate drive for external N-channel FET

.

Adjustable analog current limit with circuit breaker

.

±3% accurate hot swap current limit level

.

Fast response limits peak fault current

.

Automatic retry or latch-off on current fault

.

Programmable hot swap timing via TIMER pin

.

Soft start pin for reference adjustment and programming of initial current ramp rate

.

Active high ON pin