MCU 8Bit ATtiny AVR RISC 2KB Flash 2.5V/3.3V/5V 12Pin WLCSP T/R
Overview
ATtiny20 is a low-power CMOS 8-bit microcontroller based on the compact AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATtiny20 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.
Features
• High performance, low power 8-bit AVR® microcontroller
• Advanced RISC architecture
• 112 powerful instructions – most single clock cycle execution
• 16 x 8 general purpose working registers
• Fully static operation
• Up to 12 MIPS throughput at 12MHz
• Non-volatile program and data memories
• 2K bytes of in-system programmable flash program memory
• 128 bytes internal SRAM
• Flash write/erase cycles: 10,000
• Data retention: 20 years at 85oC / 100 years at 25oC
• Peripheral features
• One 8-bit timer/counter with two PWM channels
• One 16-bit timer/counter with two PWM channels
• 10-bit analog to digital converter
• 8 single-ended channels
• Programmable watchdog timer with separate on-chip oscillator
• On-chip analog comparator
• Master/slave SPI serial interface
• Slave TWI serial interface
• Special microcontroller features
• In-system programmable
• External and internal interrupt sources
• Low power idle, ADC noise reduction, stand-by and power-down modes
• Enhanced power-on reset circuit
• Internal calibrated oscillator
• I/O and packages
• 14-pin SOIC/TSSOP: 12 programmable I/O lines
• 12-ball WLCSP: 10 programmable I/O lines
• 15-ball UFBGA: 12 programmable I/O lines
• 20-pad VQFN: 12 programmable I/O lines
• Operating voltage:
• 1.8 – 5.5V
• Programming voltage:
• 5V
• Speed grade
• 0 – 4MHz @ 1.8 – 5.5V
• 0 – 8MHz @ 2.7 – 5.5V
• 0 – 12MHz @ 4.5 – 5.5V
• Industrial temperature range
• Low power consumption
• Active mode:
• 200 μA at 1MHz and 1.8V
• Idle mode:
• 25μA at 1MHz and 1.8V
• Power-down mode:
• < 0.1μA at 1.8V