ATMEGA162-16AI

MCU 8Bit ATmega AVR RISC 16KB Flash 3.3V/5V 44Pin TQFP

Overview

The ATmega162 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega162 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.

Features

• High-performance, Low-power AVR® 8-bit Microcontroller

• Advanced RISC Architecture

   – 131 Powerful Instructions – Most Single-clock Cycle Execution

   – 32 x 8 General Purpose Working Registers

   – Fully Static Operation

   – Up to 16 MIPS Throughput at 16 MHz

   – On-chip 2-cycle Multiplier

• High Endurance Non-volatile Memory segments

   – 16K Bytes of In-System Self-programmable Flash program memory

   – 512 Bytes EEPROM

   – 1K Bytes Internal SRAM

   – Write/Erase cycles: 10,000 Flash/100,000 EEPROM

   – Data retention: 20 years at 85°C/100 years at 25°C1

   – Optional Boot Code Section with Independent Lock Bits In-System Programming by On-chip Boot Program True Read-While-Write Operation

   – Up to 64K Bytes Optional External Memory Space

   – Programming Lock for Software Security

• JTAG IEEE std. 1149.1 Compliant Interface

   – Boundary-scan Capabilities According to the JTAG Standard

   – Extensive On-chip Debug Support

   – Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG Interface

• Peripheral Features

   – Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes

   – Two 16-bit Timer/Counters with Separate Prescalers, Compare Modes, and Capture Modes

   – Real Time Counter with Separate Oscillator

   – Six PWM Channels

   – Dual Programmable Serial USARTs

   – Master/Slave SPI Serial Interface

   – Programmable Watchdog Timer with Separate On-chip Oscillator

   – On-chip Analog Comparator

• Special Microcontroller Features

   – Power-on Reset and Programmable Brown-out Detection

   – Internal Calibrated RC Oscillator

   – External and Internal Interrupt Sources

   – Five Sleep Modes: Idle, Power-save, Power-down, Standby, and Extended Standby

• I/O and Packages

   – 35 Programmable I/O Lines

   – 40-pin PDIP, 44-lead TQFP, and 44-pad MLF

• Operating Voltages

   – 1.8 - 5.5V for ATmega162V

   – 2.7 - 5.5V for ATmega162

• Speed Grades

   – 0 - 8 MHz for ATmega162V see Figure 113 on page 266

   – 0 - 16 MHz for ATmega162 see Figure 114 on page 266