热插拔控制器和数字电源监控与转换针脚 Hot Swap Controller and Digital Power Monitor with Convert Pin
Product Details
The ADM1175 is an integrated hot swap controller and current sense amplifier that offers digital current and voltage monitoring via an on-chip, 12-bit analog-to-digital converter ADC, communicated through an I2C interface.
An internal current sense amplifier senses voltage across the sense resistor in the power path via the VCC pin and the SENSE pin.
The ADM1175 limits the current through this resistor by controlling the gate voltage of an external N-channel FET in the power path, via the GATE pin. The sense voltage and, therefore, the inrush current is kept below a preset maximum.
The ADM1175 protects the external FET by limiting the time that it spends with maximum current running through it. This current limit period is set by the choice of capacitor attached to the TIMER pin. Additionally, the device provides protection from overcurrent events that may occur once the hot swap event is complete. In the case of a short-circuit event, the current in the sense resistor exceeds an overcurrent trip threshold, and the FET is switched off immediately by pulling down the GATE pin.
A 12-bit ADC can measure the current seen in the sense resistor, as well as the supply voltage on the VCC pin. An industry-standard I2C interface allows a controller to read current and voltage data from the ADC. Measurements can be initiated by an I2C command or via the convert CONV pin. The CONV pin is especially useful for synchronizing reads on multiple ADM1175 devices. Alternatively, the ADC can run continuously, and the user can read the latest conversion data whenever it is required. Up to four unique I2C addresses can be created, depending on the way the ADR pin is connected.
The ADM1175 is packaged in a 10-lead MSOP.
**Applications**
- .
- Power monitoring/power budgeting
- .
- Central office equipment
- .
- Telecommunication and data communication equipment
- .
- PCs/servers
### Features and Benefits
- .
- Allows safe board insertion and removal from a live backplane
- .
- Controls supply voltages from 3.15 V to 16.5 V
- .
- Precision current sense amplifier
- .
- Precision voltage input
- .
- 12-bit ADC for current and voltage readback
- .
- Charge pumped gate drive for external N-channel FET
- .
- 10-lead MSOP
- .
- Convert start pin CONV
- .
- Adjustable analog current limit with circuit breaker
- .
- ±3% accurate hot swap current limit level
- .
- Fast response limits peak fault current
- .
- Automatic retry or latch-off on current fault
- .
- Programmable hot swap timing via TIMER pin
- .
- Active-high and active-low ON/ONB pin options
- .
- I2C fast mode-compliant interface 400 kHz maximum
