MCU 32Bit Stellaris ARM Cortex M3 RISC 64KB Flash 2.5V/3.3V 100Pin LQFP Tray
* 32-bit ARM® Cortex™-M3 25-MHz processor core with System Timer SysTick, integrated Nested Vectored Interrupt Controller NVIC, Memory Protection Unit MPU, and Thumb-2 instruction set * Full-featured debug solution with debug access via JTAG and Serial Wire interfaces, and IEEE 1149.1-1990 compliant Test Access Port TAP controller * 64 KB single-cycle flash and 16 KB single-cycle SRAM * 10-30 GPIOs depending on configuration with programmable control for GPIO interrupts and pad configuration * ARM FiRM-compliant Watchdog Timer ; plus three General-Purpose Timer Modules GPTM, each of which provides two 16-bit timers/counters and can be configured to operate independently * 10-bit Analog-to-Digital Converter ADC withanalog input channels and a sample rate ofsamples/second * Fully programmable 16C550-type UART with IrDA support * Synchronous Serial Interface SSI, supporting operation for Freescale SPI, MICROWIRE, or Texas Instruments synchronous serial interfaces * Highly configurable 10/100 Ethernet Controller that conforms to the IEEE 802.3-2002 specification with full- and half-duplex modes for both 100 Mbps and 10 Mbps operation, and automatic MDI/MDI-X cross-over correction * One integrated analog comparator configurable for output to drive an output pin or generate an interrupt * Industrial and extended temperature RoHS-compliant 100-pin LQFP package and industrial-range RoHS-compliant 108-ball BGA package