KEIL MCB1850 Evaluation Board, LPC1850 Cortex M3 MCU, Push buttons, USB Interface and powered
is a Keil MCB1800 evaluation board which enables to create and test working programs based on the NXP LPC1850 ARM Cortex-M3 processor based device. The NXP LPC1850 microcontroller provided with the MCB1800 board is a high end LPC devices with on chip CAN, Ethernet, USB full and high-speed connectivity. A 12MHz oscillator provides the clock signal for the MCU. The JTAG/Cortex debug Interface connector provides debugging and emulator support for the LPC1850 device. The JTAG/Cortex debug Interface allows application debugging and programming of on chip and off chip flash devices. And also supports the Serial Wire Mode of Cortex-M3 based devices. The MCB1800 board connects the on chip serial UARTs to the ST3232C, which converts the logic signals to RS232 voltage levels.
- .
- 180MHz ARM Cortex-M3 processor based MCU in LBGA256
- .
- On chip SRAM 200KB
- .
- On board memory of 16MB NOR flash, 4MB Quad SPI flash, 16MB SDRAM, and 16KB EEPROM I2C
- .
- Colour QVGA TFT LCD with touch screen
- .
- 10/100 Ethernet port
- .
- High speed USB 2.0 Host/Device/OTG interface, Full speed USB 2.0 Host/Device interface
- .
- CAN interfaces, serial/UART port, MicroSD card interface
- .
- Audio CODEC with line In/Out and microphone/headphone connector + speaker
- .
- Analog voltage control for ACD input
- .
- 20 pin JTAG, 10 pin Cortex debug, 20 pin Cortex debug + ETM trace