SN74LV245ARGYR

SN74LV245ARGYR图片1
SN74LV245ARGYR图片2
SN74LV245ARGYR图片3
SN74LV245ARGYR图片4
SN74LV245ARGYR图片5
SN74LV245ARGYR图片6
SN74LV245ARGYR图片7
SN74LV245ARGYR图片8
SN74LV245ARGYR图片9
SN74LV245ARGYR图片10
SN74LV245ARGYR图片11
SN74LV245ARGYR图片12
SN74LV245ARGYR图片13
SN74LV245ARGYR图片14
SN74LV245ARGYR概述

IC 总线收发器 SN74LV245ARGYR VFQFN-20 marking/标记 LV245A

逻辑类型Logic Type| 收发器,非反相 Transceiver, Non-Inverting \---|--- 电路数Number of Circuits| 1 输入数Number of Inputs| 8 电源电压VccVoltage - Supply| 2 V ~ 3.6 V 静态电流IqCurrent - Quiescent Max| 16mA,16mA 输出高,低电平电流Current - Output High, Low| OCTAL BUS TRANSCEIVERS WITH 3-STATE OUTPUTS description/ordering information continued The ’LV245A devices are designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control DIR input. The output-enable OE input can be used to disable the device so the buses are effectively isolated. To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver. These devices are fully specified for partial-power-down applications using Ioff The Iof circuitry disables the outputs, preventing damaging current backflow through the devices when they are powered down. 2-V to 5.5-V VCC Operation Max tpd of 6.5 ns at 5 V Typical VOLP Output Ground Bounce <0.8 V at VCC = 3.3 V, TA = 25°C Typical VOHV Output VOH Undershoot >2.3 V at VCC = 3.3 V, TA = 25°C Support Mixed-Mode Voltage Operation on All Ports off Supports Partial-Power-Down Mode Operation Latch-Up Performance Exceeds 250 mA Per JESD 17 ESD Protection Exceeds JESD 22 2000-V Human-Body Model A114-A 200-V Machine Model A115-A 1000-V Charged-Device Model C101 低逻辑电平Logic Level - Low| 具有三态输出的八路总线收发器 描述/订购信息(续) "LV245A设备是专为数据总线之间的异步通信。该装置 发送数据从A总线到B总线或从B总线到A总线,这取决于对逻辑电平 方向控制(DIR)输入。输出使能(OE)输入可用于禁用设备,以便巴士 有效隔离。 为了确保在开机或断电高阻抗状态,OE应当连接到VCC通过上拉 电阻,电阻的最小值确定的驱动器的电流吸收能力。 这些器件是完全指定部分断电应用程序使用IOFF IOF电路将禁用 输出,防止损坏电流回流通过这些器件的时候都 断电。 “2 V至5.5 V的VCC操作 最大5 V时为6.5 ns吨 典型的VoIP(输出地弹跳) <0.8 V在VCC =3.3 V,TA= 25°C 典型的VOHV(输出VOH冲) >2.3 V在VCC =3.3 V,TA= 25°C 支持混合模式的工作电压 关闭所有端口支持部分掉电模式 手术 闭锁性能超过250 mA每 JESD17 ESD保护超过JESD22 2000-V人体模型(A114-A) 200-V机型号(A115-A) 1000-V带电器件模型(C101“ 高逻辑电平Logic Level - High| 传播延迟时间@Vcc,CLMax Propagation Delay @ V, Max CL| Description & Applications| 描述与应用|

SN74LV245ARGYR中文资料参数规格
技术参数

电源电压DC 2.00V ~ 5.50V

电路数 8

通道数 8

位数 8

电压波节 5.00 V, 3.30 V, 2.50 V

输出电流驱动 -1.00 mA

工作温度Max 125 ℃

工作温度Min -40 ℃

电源电压 2V ~ 5.5V

电源电压Max 5.5 V

电源电压Min 2 V

封装参数

安装方式 Surface Mount

引脚数 20

封装 VQFN-20

外形尺寸

封装 VQFN-20

物理参数

工作温度 -40℃ ~ 125℃ TA

其他

产品生命周期 Active

包装方式 Tape & Reel TR

符合标准

RoHS标准 RoHS Compliant

含铅标准 Lead Free

数据手册

SN74LV245ARGYR引脚图与封装图
SN74LV245ARGYR引脚图
SN74LV245ARGYR封装图
SN74LV245ARGYR封装焊盘图
在线购买SN74LV245ARGYR
型号: SN74LV245ARGYR
制造商: TI 德州仪器
描述:IC 总线收发器 SN74LV245ARGYR VFQFN-20 marking/标记 LV245A

锐单商城 - 一站式电子元器件采购平台