2.1 LIN / SAE J2602收发器 LIN 2.1/SAE J2602 transceiver
General description
The TJA1021 is the interface between the Local Interconnect Network LIN master/slave protocol controller and the physical bus in a LIN. It is primarily intended for in-vehicle sub-networks using baud rates from 1 kBd up to 20 kBd and is LIN 2.1/SAE J2602 compliant. The TJA1021 is pin-to-pin compatible with the TJA1020 with an improved ElectroStatic Discharge ESD specification.
The transmit data stream of the protocol controller at the transmit data input TXD is converted by the TJA1021 into a bus signal with optimized slew rate and wave shaping to minimize ElectroMagnetic Emission EME. The LIN bus output pin is pulled HIGH via an internal termination resistor. For a master application, an external resistor in series with a diode should be connected between pin INH or pin VBATand pin LIN. The receiver detects the data stream at the LIN bus input pin and transfers it via pin RXD to the microcontroller.
In Sleep mode, the power consumption of the TJA1021 is very low. In failure modes, the power consumption is reduced to a minimum.
Features and benefits
2.1 General
LIN 2.1/SAE J2602 compliant
Baud rate up to 20 kBd
Very low ElectroMagnetic Emission EME
High ElectroMagnetic Immunity EMI
Passive behavior in unpowered state
Input levels compatible with 3.3 V and 5 V devices
Integrated termination resistor for LIN slave applications
Wake-up source recognition local or remote
Supports K-line like functions
Pin-to-pin compatible with TJA1020
2.2 Low power management
Very low current consumption in Sleep mode with local and remote wake-up
2.3 Protection mechanisms
High ESD robustness: 6 kV according to IEC 61000-4-2 for pins LIN, VBATand WAKE_N
Transmit data TXD dominant time-out function
Bus terminal and battery pin protected against transients in the automotive environment ISO 7637
Bus terminal short-circuit proof to battery and ground
Thermally protected