TPS61013

具有固定 2.5V 输出的低输入电压同步升压转换器

The TPS6101x devices are boost converters intended for systems that are typically operated from a single- or dual-cell nickel-cadmium NiCd, nickel-metal hydride NiMH, or alkaline battery.

The converter output voltage can be adjusted from 1.5 V to a maximum of 3.3 V, by an external resistor divider or, is fixed internally on the chip. The devices provide an output current of 200 mA with a supply voltage of only 0.9 V. The converter starts up into a full load with a supply voltage of only 0.9 V and stays in operation with supply voltages down to 0.8 V.

The converter is based on a fixed frequency, current mode, pulse-width-modulation PWM controller that goes automatically into power save mode at light load. It uses a built-in synchronous rectifier, so, no external Schottky diode is required and the system efficiency is improved. The current through the switch is limited to a maximum value of 1300 mA. The converter can be disabled to minimize battery drain. During shutdown, the load is completely isolated from the battery.

An autodischarge function allows discharging the output capacitor during shutdown mode. This is especially useful when a microcontroller or memory is supplied, where residual voltage across the output capacitor can cause malfunction of the applications. When programming the ADEN-pin, the autodischarge function can be disabled. A low-EMI mode is implemented to reduce interference and radiated electromagnetic energy when the converter enters the discontinuous conduction mode. The device is packaged in the micro-small space saving 10-pin MSOP package. The TPS61010 is also available in a 3 mm × 3 mm 10-pin QFN package.

.

Integrated Synchronous Rectifier for Highest

Power Conversion Efficiency > 95%

.

Start-Up Into Full Load With Supply Voltages as

Low as 0.9 V, Operating Down to 0.8 V

.

200-mA Output Current From 0.9-V Supply

.

Powersave-Mode for Improved Efficiency at Low

Output Currents

.

Autodischarge Allows to Discharge Output

Capacitor During Shutdown

.

Device Quiescent Current Less Than 50 µA

.

Ease-of-Use Through Isolation of Load From

Battery During Shutdown of Converter

.

Integrated Antiringing Switch Across Inductor

.

Integrated Low Battery Comparator

.

Micro-Small 10-Pin MSOP or 3 mm × 3 mm QFN

Package

.

EVM Available TPS6101xEVM-157