TLE4998S8XUMA1

霍尔效应传感器, 线性, 5 mA, SOIC, 8 引脚, 4.5 V, 5.5 V

Description:

The linear Hall IC TLE4998S8 has been designed specifically to meet the requirements of highly accurate angle and position detection. The sensor provides a digital SENT signal based on the SAE J2716 standard, which consists of a sequence of pulses. Each transmission consists of multiple data nibbles containing the Hall value, the temperature and status information of the sensor. The output stage is an open-drain driver pulling the output pin to low only. Therefore, the high level needs to be obtained by an external pull-up resistor. This output type has the advantage that the receiver may use an even lower supply voltage e.g. 3.3 V. In this case the pull-up resistor must be connected to the given receiver supply.

Summary of Features:

.

Integration of two individual Linear Hall sensor IC’s with Single Edge Nibble Transmission SENT open-drain

.

output signal SAE J2716

.

20-bit Digital Signal Processing DSP

.

Digital temperature and stress compensation

.

16-bit overall resolution

.

Operating automotive temperature range -40°C to 125°C

.

Minimal drift of output signal over temperature and lifetime

.

Programmable parameters stored in EEPROM with single-bit error correction:

.

SENT unit time

.

Magnetic range, sensitivity gain, offset, and polarity of the output slope

.

Filter Bandwidth

.

Clamping levels�

.

Customer temperature compensation coefficients for all common magnets

.

Re-programmable until memory lock

.

Supply voltage 4.5-5.5 V 4.1-16 V extended range

.

Configurable magnetic range: ±50 mT, ±100 mT, or ±200 mT

.

Reverse-polarity and overvoltage protection for all pins

.

Output short-circuit protection

.

On-board diagnostics overvoltage, EEPROM error

.

Output of internal magnetic field values and temperature

.

Programming and operation of multiple sensors with common power supply

.

Two-point calibration of magnetic transfer function without iteration steps