TLC59116IPWRG4

16通道FM + I2C -BUS恒流LED驱动器 16-CHANNEL Fm+ I2C-BUS CONSTANT-CURRENT LED SINK DRIVER

Description

The TLC59116 is an I2C bus controlled 16-channel LED driver that is optimized for red/green/blue/amber RGBA color mixing and backlight application. Each LED output has its own 8-bit resolution 256 steps fixed-frequency individual PWM controller that operates at 97 kHz, with a duty cycle that is adjustable from 0% to 99.6%.

Features

• 16 LED Drivers Each Output Programmable at Off, On, Programmable LED Brightness, or Programmable Group Dimming and Blinking Mixed With Individual LED Brightness

• 16 Constant-Current Output Channels

• 256-Step 8-Bit Linear Programmable Brightness Per LED Output Varying From Fully Off Default to Maximum Brightness Using a 97-kHz PWM Signal

• 256-Step Group Brightness Control Allows General Dimming [Using a 190-Hz PWM Signal From Fully Off to Maximum Brightness Default]

• 256-Step Group Blinking With Frequency Programmable From 24 Hz to 10.73 s and Duty Cycle From 0% to 99.6%

• Four Hardware Address Pins Allow 14 TLC59116 Devices to Be Connected to Same I2C Bus

• Four Software-Programmable I2C Bus Addresses One LED Group Call Address and Three LED Sub Call Addresses Allow Groups of Devices to Be Addressed at Same Time in Any Combination

• Software Reset Feature SWRST Call Allows Device to Be Reset Through I2C Bus

• Up to 14 Possible Hardware-Adjustable Individual I2C Bus Addresses Per Device, So That Each Device Can Be Programmed

• Open-Load and Overtemperature Detection Mode to Detect Individual LED Errors

• Output State Change Programmable on Acknowledge or Stop Command to Update Outputs Byte-by-Byte or All at Same Time Default to Change on Stop

• Output Current Adjusted Through an External Resistor

• Constant Output Current Range: 5 mA to 120 mA

• Maximum Output Voltage: 17 V

• 25-MHz Internal Oscillator Requires No External Components

• 1-MHz Fast-mode Plus FMT Compatible I2C Bus Interface With 30-mA High-Drive Capability on SDA Output for Driving High-Capacitive Buses

• Internal Power-On Reset

• Noise Filter on SCL and SDA Inputs

• No Glitch on Power-Up

• Active-Low Reset

• Supports Hot Insertion

• Low Standby Current

• 3.3-V or 5-V Supply Voltage

• 5.5-V Tolerant Inputs

• Offered in 28-Pin Thin Shrink Small-Outline

   Package TSSOP PW and 32-Pin Quad

   Flatpack No Lead QFN

• –40 °C to 85 °C Operation

Applications

• Gaming

• Small Signage

• Industrial Equipment