AD5627RBCPZ-R2

双通道， 12位/ 14位/ 16位nanoDACs® 5 PPM / ° C片参考， I 2 C接口 Dual, 12-/14-/16-Bit nanoDACs® with 5 ppm/°C On-Chip Reference, I2C® Interface

12 位数模转换器 2 10-LFCSP-WD（3x3）

得捷:
IC DAC 12BIT V-OUT 10LFCSP

艾睿:
DAC 2-CH Resistor-String 12-bit 10-Pin LFCSP EP T/R

安富利:
The AD5627 member of the nanoDAC family are low power, dual, 12-, 14-, 16-bit buffered voltage-out DACs with/without on-chip reference. All devices operate from a single 2.7 V to 5.5 V supply, are guaranteed monotonic by design, and have an I2 C-compatible serial interface.The AD5627 have an on-chip reference. The AD56x7RBCPZ have a 1.25 V, 5 ppm/°C reference, giving a full-scale output range of 2.5 V; the AD56x7RBRMZ have a 2.5 V, 5 ppm/°C reference, giving a full-scale output range of 5 V. The on-chip reference is off at power-up, allowing the use of an external reference. The internal reference is enabled via a software write. The AD5667 and AD5627 require an external reference voltage to set the output range of the DAC.The AD56x7R/AD56x7 incorporate a power-on reset circuit that ensures the DAC output powers up to 0 V, and remains there until a valid write takes place. The part contains a perchannel power-down feature that reduces the current consumption of the device to 480 nA at 5 V and provides software-selectable output loads while in power-down mode. The low power consumption of this part in normal operation makes it ideally suited to portable battery-operated equipment. The on-chip precision output amplifier enables rail-to-rail output swing. The AD56x7R/AD56x7 use a 2-wire I2 C-compatible serial interface that operates in standard 100 kHz, fast 400 kHz, and high speed 3.4 MHz modes.

Chip1Stop:
DAC 2-CH Resistor-String 12-bit 10-Pin LFCSP EP T/R

罗切斯特:
AD5627R - Dual, 12-Bit NANODACS with 5 PPM/Degree Centigrade On-Chip Reference, I2C Interface