BQ2040

符合多化合物智能电池系统 SBS 1.0 的电量监测计，具有 4 个 LED 驱动器

The bq2040 Gas Gauge IC With SMBus Interface is intended for battery-pack or in-system installation to maintain an accurate record of available battery charge. The bq2040 directly supports capacity monitoring for NiCd, NiMH, and Li-Ion battery chemistries.

The bq2040 uses the System Management Bus v1.0 SMBus protocol and supports the Smart Battery Data SBData commands. The bq2040 also supports the SBData charge control functions. Battery state-of-charge, remaining capacity, remaining time, and chemistry are available over the serial link. Battery-charge state can be directly indicated using a four-segment LED display to graphically depict battery full-to-empty in 25% increments.

The bq2040 estimates battery self-discharge based on an internal timer and temperature sensor and user-programmable rate information stored in external EEPROM. The bq2040 also automatically recalibrates or \x93learns\x94 battery capacity in the full course of a discharge cycle from full to empty.

The bq2040 may operate directly from three nickel chemistry cells. With the REF output and an external transistor, a simple, inexpensive regulator can be built to provide VCC for other battery cell configurations.

An external EEPROM is used to program initial values into the bq2040 and is necessary for proper operation.

.

Provides accurate measurement of available charge in NiCd, NiMH, and Li-Ion batteries

.

Supports SBS v1.0 data set and two-wire interface

.

Monitors charge FET in Li-Ion pack protection circuit

.

Designed for battery pack integration

\- Low operating current

\- Complete circuit can fit on less than 3/4 square inch of PCB space

.

Supports SBS charge control commands for NiCd, NiMH, and Li-Ion

.

Drives a four-segment LED display for remaining capacity indication

.

16-pin narrow SOIC