CAT5269WI00

双数字可编程电位计（ DPP⑩ ）与256丝锥和2线接口 Dual Digitally Programmable Potentiometers DPP™ with 256 Taps and 2-wire Interface

The CAT5269 is two digital POTs integrated with control logic and 18 bytes of NVRAM memory. Each digital POT consists of a series of resistive elements connected between two externally accessible end points. The tap points between each resistive element are connected to the wiper outputs with CMOS switches. A separate 8-bit control register WCR independently controls the wiper tap switches for each digital POT. Associated with each wiper control register are four 8-bit non-volatile memory data registers DR used for storing up to four wiper settings. Writing to the wiper control register or any of the non-volatile data registers is via a 2-wire serial bus. On power-up, the contents of the first data register DR0 for each of the four potentiometers is automatically loaded into its respective wiper control registers. The CAT5269 can be used as a potentiometer or as a two terminal, variable resistor. It is intended for circuit level or system level adjustments in a wide variety of applications. It is available in the -40°C to 85°C industrial operating temperature range.

Features

---

 |

.

Two linear taper digital potentiometers

.

256 resistor taps per potentiometer

.

End to end resistance 50 kΩ or 100 kΩ

.

Potentiometer control and memory access via 2-wire interface I²C like

.

Low wiper resistance, typically 100 Ω

.

Nonvolatile memory storage for up to four wiper settings for each potentiometer

.

Automatic recall of saved wiper settings at power up

.

2.5 to 6.0 volt operation

.

Standby current less than 1 μA

.

1,000,000 nonvolatile WRITE cycles

.

100 year nonvolatile memory data retention

.

Industrial temperature range