IS25LQ080-JVLE

NOR Flash Serial-SPI 3V 8Mbit 8M x 1Bit 8Pin VVSOP

GENERAL DESCRIPTION

The IS25LQ080 is 8 Mbit Serial Peripheral Interface SPI Flash memories, providing single-, dual or quad output. The devices are designed to support a 33 MHz fclock rate in normal read mode, and 104 MHz in fast read Quad output is 100MHz, the fastest in the industry. The devices use a single low voltage power supply, ranging from 2.3 Volt to 3.6 Volt, to perform read, erase and program operations. The devices can be programmed in standard EPROM programmers.

FEATURES

• Single Power Supply Operation

\- Low voltage range: 2.3 V - 3.6 V

• Memory Organization

\- IS25LQ080: 1024K x 8 8 Mbit

• Cost Effective Sector/Block Architecture

\- 8Mb : Uniform 4KByte sectors / sixteen uniform 64KByte blocks

• Serial Peripheral Interface SPI Compatible

\- Supports single-, dual- or quad-output

\- Supports SPI Modes 0 and 3

\- Maximum 33 MHz clock rate for normal read

\- Maximum 104 MHz clock rate for fast read

\- Maximum 208MHz clock rate

\- Maximum 400MHz clock rate equivalent Quad SPI

• Byte Program Operation

\- Typical 10 us/Byte

• Page Program up to 256 Bytes Operation

\- Maximum 0.7ms per page program

• Sector, Block or Chip Erase Operation

\- Sector Erase 4KB150ms Typ

\- Block Erase  64KB500ms Typ

\- Chip Erase 2s 8Mb

• Low Power Consumption

\- Max 12 mA active read current

\- Max 20 mA program/erase current

\- Max 30 uA standby current

• Hardware Write Protection

\- Protect and unprotect the device from write operation by Write Protect WP# Pin

• Software Write Protection

\- The Block Protect BP3, BP2, BP1, BP0 bits allow partial or entire memory to be configured as read-only

• High Product Endurance

\- Guaranteed 100,000 program/erase cycles per single sector

\- Minimum 20 years data retention

• Industrial Standard Pin-out and Package

\- 8-pin 208mil SOIC

\- 8-pin 150mil VVSOP

\- 8-contact WSON

\- PDIP

\- Lead-free Pb-free package

•Additional 256-byte Security information one-time programmable OTP area

•Special protect function

-  Safe guard function Appendix 1

-  Sector unlock function Appendix 2