FTDI FT4232HQ-R 接口桥接器, USB 至 UART, MPSSE, 1.62 V, 1.98 V, QFN, 64 引脚, -40 °C
The is a 5th generation USB 2.0 High-speed 480Mbps to UART IC. It has the capability of being configured in a variety of industry standard serial or parallel interfaces. The IC features 4 UARTs. Two of these have an option to independently configure an MPSSE engine, this allows the IC to operate as two UART/bit-bang ports plus two MPSSE engines used to emulate JTAG, SPI, I²C, bit-bang or other synchronous serial modes.
-
.
-
Single chip USB to quad serial ports with a variety of configurations
-
.
-
Entire USB protocol handled on chip, no USB specific firmware programming required
-
.
-
USB 2.0 high-speed 480Mbps and full-speed 12Mbps compatible
-
.
-
Two multi-protocol synchronous serial engine MPSSE on channel A and channel B
-
.
-
Independent baud rate generators
-
.
-
RS232/RS422/RS485 UART transfer data rate up to 12Mbaud RS232 Data Rate Limited
-
.
-
FTDI"s royalty-free virtual com port VCP and direct D2XX drivers
-
.
-
Optional traffic TX/RX indicators can be added with LEDs and an external 74HC595 shift register
-
.
-
Adjustable receive buffer timeout
-
.
-
Support for USB suspend and resume conditions via PWREN#, SUSPEND# and RI# pins
-
.
-
Highly integrated design
-
.
-
FTDI FT232B style, asynchronous serial UART interface option
-
.
-
Fully assisted hardware or X-On/X-Off software handshaking
-
.
-
UART interface supports 7/8-bit data, 1/2 stop bits and odd/even/mark/space/no parity
-
.
-
Auto-transmit enable control for RS485 serial applications using TXDEN pin
-
.
-
Operational configuration mode and USB description strings configurable in external EEPROM over USB
-
.
-
Low operating and USB suspend current
-
.
-
Configurable I/O drive strength 4, 8, 12 or 16mA and slew rate
-
.
-
Supports bus powered, self powered and high-power bus powered USB configurations
-
.
-
UHCI/OHCI/EHCI host controller compatible
ESD sensitive device, take proper precaution while handling the device.