LF398M

TEXAS INSTRUMENTS  LF398M  采样保持放大器, 1个放大器, 1 MHz, 20 µs, 2 mV, SOIC, 14 引脚

The is a monolithic Sample and Hold Circuit utilizes BI-FET technology to obtain ultra-high DC accuracy with fast acquisition of signal and low droop rate. Operating as a unity gain follower, DC gain accuracy is 0.002% typical and acquisition time is as low as 6µs to 0.01%. A bipolar input stage is used to achieve low offset voltage and wide bandwidth. Input offset adjust is accomplished with a single pin and does not degrade input offset drift. The wide bandwidth allows the LF198 to be included inside the feedback loop of 1MHz op-amps without having stability problems. P-channel junction FET"s are combined with bipolar devices in the output amplifier to give droop rates as low as 5mV/min with a 1µF hold capacitor. The JFET"s have much lower noise than MOS devices used in previous designs and do not exhibit high temperature instabilities. The overall design guarantees no feed-through from input to output in the hold mode, even for input signals equal to the supply voltages.

.

<10µs Acquisition time

.

Low input offset

.

0.002% Gain accuracy

.

Low output noise in hold mode

.

Input characteristics do not change during hold mode

.

High supply rejection ratio in sample or hold

.

Wide bandwidth

.

Military rated