SN74ALVCH16409DL

9位，4端口通用总线三态输出EXCHANGER 9-BIT, 4-PORT UNIVERSAL BUS EXCHANGER WITH 3-STATE OUTPUTS

This 9-bit, 4-port universal bus exchanger is designed for 1.65-V to 3.6-V VCC operation.

The SN74ALVCH16409 allows synchronous data exchange between four different buses. Data flow is controlled by the select SEL0-SEL4 inputs. A data-flow state is stored on the rising edge of the clock CLK input if the select-enable SELEN\\\\ input is low. Once a data-flow state has been established, data is stored in the flip-flop on the rising edge of CLK if SELEN\ is high.

The data-flow control logic is designed to allow glitch-free data transmission.

When preset PRE\\\\ transitions high, the outputs are disabled immediately, without waiting for a clock pulse. To leave the high-impedance state, both PRE\ and SELEN\ must be low and a clock pulse must be applied.

To ensure the high-impedance state during power up or power down, PRE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.