MCBSTM32EXLUME

STM32F103ZG Microcontroller Starter Kit 8MHz/72MHz CPU 1.094Mb RAM 1Mb/8Mb Flash/SPI Flash

is a Keil MCBSTM32EXL evaluation boards with ULINK-ME debug adapter which enable to create and test working programs based on STM32 family of ARM Cortex-M3 processor based devices. STM32F103ZG microcontroller provided with the MCBSTM32EXL board is a high end STM32F103Zx device supporting on chip CAN and USB. A 8MHz oscillator provides the clock signal for the MCU. The JTAG interface connector provides debugging and emulator support for the STRM32F103ZG device. The JTAG interface allows application debugging and programming of on chip and off chip flash devices. Board also supports the Serial Wire Mode of Cortex-M3 based devices. The ETM interface connector provides instruction level trace debugging support for STRM32F103ZG device. Board connects the on chip serial UART to the ST3232, which converts the logic signals to RS232 voltage levels. ULINK2 debug adapter connects PC"s USB port to target system and allows to program and debug embedded programs on target hardware.

.

72MHz STM32F103ZG ARM Cortex-M3 processor based MCU in 144 pin LQFP

.

On chip memory: 1MB flash and 96KB RAM

.

External memory: 8MB SPI flash and 1MB RAM

.

USB 2.0 full speed device interface, CAN 2.0 and serial interfaces, MicroSD card interface

.

Potentiometer for ADC input

.

Up to 42 GPIO

.

QVGA LCD-TFT colour graphics display with 16bit interface

.

Speaker for analog output

.

Joystick with 5 positions, 8 user LEDs and 4 push buttons

.

Power via USB connector, debug interface connectors