UC2863

谐振模式电源控制器

The UC1861-1868 family of ICs is optimized for the control of Zero Current Switched and Zero Voltage Switched quasi-resonant converters. Differences between members of this device family result from the various combinations of UVLO thresholds and output options. Additionally, the one-shot pulse steering logic is configured to program either on-time for ZCS systems UC1865-1868, or off-time for ZVS applications UC1861-1864.

The primary control blocks implemented include an error amplifier to compensate the overall system loop and to drive a voltage controlled oscillator VCO, featuring programmable minimum and maximum frequencies. Triggered by the VCO, the one-shot generates pulses of a programmed maximum width, which can be modulated by the Zero Detection comparator. This circuit facilitates "true" zero current or voltage switching over various line, load, and temperature changes, and is also able to accommodate the resonant components" initial tolerances.

Under-Voltage Lockout is incorporated to facilitate safe starts upon power-up. The supply current during the under-voltage lockout period is typically less than 150µA, and the outputs are actively forced to the low state.

UVLO thresholds for the UC1861/62/65/66 are 16.5V ON and 10.5V OFF, whereas the UC1863/64/67/68 thresholds are 8V ON and 7V OFF. After VCC exceeds the UVLO threshold, a 5V generator is enabled which provides bias for the internal circuits and up to 10mA for external usage.

A Fault comparator serves to detect fault conditions and set a latch while forcing the output drivers low. The Soft-Ref pin serves three functions: providing soft start, restart delay, and the internal system reference.

Each device features dual 1 Amp peak totem pole output drivers for direct interface to power MOSFETS. The outputs are programmed to alternate in the UC1861/63/65/67 devices. The UC1862/64/66/68 outputs operate in unison alllowing a 2 Amp peak current.

.

Controls Zero Current Switched ZCS or Zero Voltage Switched ZVS Quasi-Resonant Converters

.

Zero-Crossing Terminated One-Shot Timer

.

Precision 1%, Soft-Started 5V Reference

.

Programmable Restart Delay Following Fault

.

Voltage-Controlled Oscillator VCO with Programmable Minimum and Maximum Frequencies from 10kHz to 1MHz

.

Low Start-Up Current 150µA typical

.

Dual 1 Amp Peak FET Drivers

.

UVLO Option for Off-Line or DC/DC Applications