MSP430F5152IRSBT

混合信号微控制器 MIXED SIGNAL MICROCONTROLLER

* Low Supply-Voltage Range: 3.6 V Down to 1.8 V * Ultra-Low Power Consumption * Active Mode AM: 180 µA/MHz * Standby Mode LPM3 WDT Mode, 3 V: 1.1 µA * Off Mode LPM4 RAM Retention, 3 V: 0.9 µA * Shutdown Mode LPM4.5, 3 V: 0.25 µA * Wakeup From Standby Mode in Less Than 5 µs * 16-Bit RISC Architecture, Extended Memory, 40-ns Instruction Cycle Time * Flexible Power-Management System * Fully Integrated LDO With Programmable Regulated Core Supply Voltage * Supply Voltage Supervision, Monitoring, and Brownout * Unified Clock System * FLL Control Loop for Frequency Stabilization * Low-Power Low-Frequency Internal Clock Source VLO * Low-Frequency Trimmed Internal Reference Source REFO * 32-kHz Crystals XT1 * High-Frequency Crystals up to 25 MHz XT1 * Hardware Multiplier Supports 32-Bit Operations * Three-Channel DMA * Up to Twelve 5-V-Tolerant Digital Push/Pull I/Os With up to 20-mA Drive Strength1 * 16-Bit Timer TD0 With Three Capture/Compare Registers and Support of High-Resolution Mode * 16-Bit Timer TD1 With Three Capture/Compare Registers and Support of High-Resolution Mode * 16-Bit Timer TA0 With Three Capture/Compare Registers * Universal Serial Communication Interfaces USCIs * USCI_A0 Supports: * Enhanced UART Supports Automatic Baud-Rate Detection * IrDA Encoder and Decoder * Synchronous SPI * USCI_B0 Supports: * I2C * Synchronous SPI * 10-Bit 200-ksps Analog-to-Digital Converter ADC * Internal Reference * Sample-and-Hold * Autoscan Feature * Up to Eight External Channels, Two Internal Channels, Including Temperature Sensor1 * Up to 16-Channel On-Chip Comparator Including an Ultra-Low-Power Mode1 * Serial Onboard Programming, No External Programming Voltage Needed * Available in 40-Pin QFN RSB, 38-Pin TSSOP DA, and 40-Pin Die-Sized BGA YFF Packages