PCF8575C

具有中断输出的远程 16 位 I2C 和 SMBus I/O 扩展器

This 16-bit I/O expander for the two-line bidirectional bus I2C is designed for 4.5-V to 5.5-V VCC operation.

The provides general-purpose remote I/O expansion for most microcontroller families via the I2C interface serial clock SCL and serial data SDA.

The device features a 16-bit quasi-bidirectional input/output I/O port P07–P00, P17–P10, including latched outputs with high-current drive capability for directly driving LEDs. Each quasi-bidirectional I/O can be used as an input or output without the use of a data-direction control signal. At power on, the I/Os are in 3-state mode. The strong pullup to VCC allows fast-rising edges into heavily loaded outputs. This device turns on when an output is written high and is switched off by the negative edge of SCL. The I/Os should be high before being used as inputs. After power on, as all the I/Os are set to 3-state, all of them can be used as inputs. Any change in setting of the I/Os as either inputs or outputs can be done with the write mode. If a high is applied externally to an I/O that has been written earlier to low, a large current IOL flows to GND.

.

I2C to Parallel-Port Expander

.

Open-Drain Interrupt Output

.

Low Standby-Current Consumption of

10 µA Maximum

.

Compatible With Most Microcontrollers

.

400-kHz Fast I2C Bus

.

Address by Three Hardware Address Pins

for Use of up to Eight Devices

.

Latched Outputs With High-Current Drive

Capability for Directly Driving LEDs

.

Latch-Up Performance Exceeds 100 mA

Per JESD 78, Class II

.

ESD Protection Exceeds JESD 22

.

2000-V Human-Body Model

.

200-V Machine Model

.

1000-V Charged-Device Model