ADG5436FBCPZ-RL7

Analog Switch Dual SPDT 16Pin LFCSP T/R

Product Details

The ADG5436F is an analog multiplexer, containing two independently selectable single-pole, double-throw SPDT switches. An EN input is used to disable all the switches. For use in multiplexer applications, both switches exhibit break-before-make switching action.

Each channel conducts equally well in both directions when on, and each switch has an input signal range that extends to the supplies. The digital inputs are compatible with 3 V logic inputs over the full operating supply range.

When no power supplies are present, the switch remains in the off condition, and the channel inputs are high impedance. Under normal operating conditions, if the analog input signal level on any Sxx pin exceeds VDD or VSS by a threshold voltage, VT, the channel turns off and that Sxx pin becomes high impedance. If the channel is on, the drain pin reacts according to the drain response DR input pin. If the DR pin is left floating or pulled high, the drain remains high impedance and floats. If the DR pin is pulled low, the drain pulls to the exceeded rail. Input signal levels of up to +55 V or −55 V relative to ground are blocked, in both the powered and unpowered conditions. The low on resistance of the ADG5436F, combined with the on-resistance flatness over a significant portion of the signal range, makes it an ideal solution for data acquisition and gain switching applications where excellent linearity and low distortion are critical.

Note that, throughout this data sheet, the dual function pin names are referenced only by the relevant function where applicable. See the Pin Configuration and Function Descriptions section for full pin names and function descriptions.

Product Highlights

1. Source pins are protected against voltages greater than the supply rails, up to −55 V and +55 V.

2. Source pins are protected against voltages between −55 V and +55 V in an unpowered state.

3. Overvoltage detection with digital output indicates the operating state of the switches.

4. Trench isolation guards against latch-up.

5. Optimized for low on resistance and on-resistance flatness.

6. The ADG5436F operates from a dual supply of ±5 V up to ±22 V, or a single power supply of 8 V up to 44 V.

Applications

.

Analog input/output modules

.

Process control/distributed control systems

.

Data acquisition

.

Instrumentation

.

Avionics

.

Automatic test equipment

.

Communication systems

.

Relay replacement

### Features and Benefits

.

Overvoltage protection up to −55 V and +55 V

.

Power-off protection up to −55 V and +55 V

.

Overvoltage detection on source pins

.

Interrupt flags indicate fault status

.

Low on resistance: 10 Ω typical

.

On-resistance flatness of 0.5 Ω maximum

.

6 kV human body model HBM ESD rating

.

Latch-up immune under any circumstance

.

Known state without digital inputs present

.

VSS to VDD analog signal range

.

±5 V to ±22 V dual supply operation

.

8 V to 44 V single-supply operation

.

Fully specified at ±15 V, ±20 V, +12 V, and +36 V