3V 至 5.5V 多通道 RS-232 1Mbit/s 线路驱动器/接收器
* Meets or Exceeds the Requirements of A/EIA-232-F and ITU v.28 Standards
## DESCRIPTION/ORDERING INFORMATION
The consists of five line drivers, three line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin serial-port connection pins, including GND. The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. This device operates at data signaling rates of 250 kbit/s in normal operating mode MBAUD = GND and 1Mbit/s when MBAUD = VCC. The driver output slew rate is a maximum of 30 V/µs.
The TRS3237E transmitters are disabled and the outputs are forced into high-impedance state when the device is in shutdown mode SHDN = GND and the supply current falls to less than 1 µA. Also, during shutdown, the onboard charge pump is disabled; V+ is lowered to VCC, and V– is raised toward GND. Receiver outputs also can be placed in the high-impedance state by setting enable EN high. ROUT1B remains active all the time, regardless of the EN and SHDN condition.
The TRS3237EC is characterized for operation from 0°C to 70°C. The TRS3237EI is characterized for operation from –40°C to 85°C.
型号 | 品牌 | 下载 |
---|---|---|
TRS3237E | TI 德州仪器 | 下载 |
TRS3386ECPWR | TI 德州仪器 | 下载 |
TRS3232EQPWRQ1 | TI 德州仪器 | 下载 |
TRS3253EIRSMR | TI 德州仪器 | 下载 |
TRS3243IPWR | TI 德州仪器 | 下载 |
TRS3243ECDBR | TI 德州仪器 | 下载 |
TRS3221ECPWR-LI | TI 德州仪器 | 下载 |
TRS3227CDBR | TI 德州仪器 | 下载 |
TRS3221CPWR | TI 德州仪器 | 下载 |
TRS3243ECPWR | TI 德州仪器 | 下载 |
TRS3243CDBR | TI 德州仪器 | 下载 |