SN65HVD101EVM

TEXAS INSTRUMENTS  SN65HVD101EVM  评估模块, 用于SN65HVD101和SN65HVD102设备, IO-LINK驱动器

The is an evaluation platform for SN65HVD101 and SN65HVD102 devices. The SN65HVD101 and SN65HVD102 IO-LINK PHYs implement the IO-LINK interface for industrial point to point communication. When the device is connected to an IO-Link master through a three wire interface, the master can initiate communication and exchange data with the remote node while the SN65HVD101/102 acts as a complete physical layer for the communication. The IO-LINK driver output CQ can be used in push pull, high side or low side configurations using the EN and TX input pins. The PHY receiver converts the 24V IO-LINK signal on the CQ pin to standard logic levels on the RX pin. A simple parallel interface is used to receive and transmit data and status information between the PHY and the local controller.

.

Configurable CQ output

.

Remote wake up indicator

.

Current limit indicator

.

Configurable current limits

.

9V to 36V supply range

.

Power good indicator

.

Overtemperature protection

.

Reverse polarity protection

.

Tolerant to 50V peak line voltage

.

Configurable 3.3V/5V Integrated LDO HVD101 only

This device has limited built in ESD protection. The leads should be shorted together or device placed in conductive foam during storage or handling to prevent electrostatic damage to the MOS gates.

This evaluation module is not a finished electrical equipment and not intended for consumer use.