SN74LVC1T45QDCKRQ1

TEXAS INSTRUMENTS  SN74LVC1T45QDCKRQ1  收发器, 3态, 非反相, 1.65 V至5.5 V, SC-70-6

The is a single-bit dual-supply Bus Transceiver with configurable voltage translation and 3-state outputs. This non-inverting bus transceiver uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.65 to 5.5V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.65 to 5.5V. This allows for universal low-voltage bidirectional translation between any of the 1.8/2.5/3.3/5V voltage nodes. It is designed for asynchronous communication between two data buses. The logic levels of the direction-control DIR input activate either the B-port outputs or the A-port outputs. The device transmits data from the A bus to the B bus when the B-port outputs are activated and from the B bus to the A bus when the A-port outputs are activated. The input circuitry on both A and B ports always is active and must have a logic HIGH or LOW level applied to prevent excess ICC and ICCZ.

.

Customer-specific configuration control can be supported along with major-change approval

.

VCC Isolation - If either VCC input is at GND, both ports are in the high-impedance state

.

DIR Input circuit referenced to VCCA

.

IOFF Supports partial-power-down mode operation

.

Fully configurable dual-rail design allows port to operate over the full 1.65 to 5.5V supply range

.

±24mA Output drive at 3.3V

.

Green product and no Sb/Br