1:10 DDR 锁相环时钟驱动器
The is a high-performance, low-skew, low-jitter zero delay buffer that distributes a differential clock input pair CLK, CLK\\ to ten differential pairs of clock outputs Y[0:9], Y[0:9]\\ and one differential pair of feedback clock output FBOUT, FBOUT\\. The clock outputs are controlled by the clock inputs CLK, CLK\\, the feedback clocks FBIN, FBIN\\, and the analog power input AVDD. When PWRDWN\ is high, the outputs switch in phase and frequency with CLK. When PWRDWN\ is low, all outputs are disabled to high impedance state 3-state, and the PLL is shut down low power mode. The device also enters this low power mode when the input frequency falls below a suggested detection frequency that is below 20 MHz typical 10 MHz. An input frequency detection circuit will detect the low frequency condition and after applying a >20 MHz input signal this detection circuit turns on the PLL again and enables the outputs.
When AVDD is strapped low, the PLL is turned off and bypassed for test purposes. The CDCV857 is also able to track spread spectrum clocking for reduced EMI.
Since the CDCV857 is based on PLL circuitry, it requires a stabilization time to achieve phase-lock of the PLL. This stabilization time is required following power up. The CDCV857 is characterized for operation from 0°C to 85°C.
型号 | 品牌 | 下载 |
---|---|---|
CDCV857 | TI 德州仪器 | 下载 |
CDCV304PW | TI 德州仪器 | 下载 |
CDCVF2310PW | TI 德州仪器 | 下载 |
CDCVF310PW | TI 德州仪器 | 下载 |
CDCV304PWR | TI 德州仪器 | 下载 |
CDCVF2505D | TI 德州仪器 | 下载 |
CDCVF855PW | TI 德州仪器 | 下载 |
CDCVF25081D | TI 德州仪器 | 下载 |
CDCV850IDGG | TI 德州仪器 | 下载 |
CDCVF2509PW | TI 德州仪器 | 下载 |
CDCV855PW | TI 德州仪器 | 下载 |