LPC1810FET100,551

LPC1810 系列 32 位 136 KB SRAM 微控制器 - TFBGA-100

Overview

The LPC1810FET100 is a high-performance, cost-effective Cortex-M3 microcontroller featuring 136 kB of SRAM, and advanced peripherals including CAN 2.0B. Operating at speeds up to 180 MHz, the LPC1810 also features two new configurable peripherals: a SPI Flash Interface and a State Configurable Timer. All members of the series include a Wakeup Interrupt Controller allowing automatic wake from any priority interrupt as well as four reduced power modes: Sleep, Deep-Sleep, Power-Down, and Deep Power-Down.

MoreLess

## Features

* ARM Cortex-M3 processor, running at frequencies of up to 180 MHz

* ARM Cortex-M3 built-in Memory Protection Unit MPU supporting eight regions

* ARM Cortex-M3 built-in Nested Vectored Interrupt Controller NVIC

* Non-maskable Interrupt NMI input

* JTAG and Serial Wire Debug

* ETM and ETB support

* System tick timer

* 136 kB SRAM for code and data use

* 32 kB ROM containing boot code and on-chip software drivers

* Crystal oscillator with an operating range of 1 MHz to 25 MHz

* 12 MHz internal RC oscillator trimmed to 1 % accuracy

* Ultra-low power RTC crystal oscillator

* Clock output

* Two PLLs allow CPU operation up to the maximum CPU rate

* Quad SPI Flash Interface with four lanes and data rates of up to 40 MB/s

* Four 550 UARTs with DMA support: one UART with full modem interface

* One UART with IrDA interface

* One C_CAN 2.0B controller with one channel

* Two SSP controllers with FIFO and multi-protocol support

* One Fast-mode Plus I2C-bus interface with monitor mode

* One standard I2C-bus interface with monitor mode and standard I/O pins

* One I2S interface with DMA support and with one input and one output

* External Memory Controller EMC

* SD/MMC card interface

* Eight-channel General-Purpose DMA GPDMA controller

* Up to 49 General-Purpose Input/Output GPIO pins

* GPIO registers are located on the AHB for fast access

* State Configurable Timer SCT subsystem on AHB

* Four general-purpose timer/counters with capture and match capabilities

* One motor control PWM for three-phase motor control

* One Quadrature Encoder Interface QEI

* Repetitive Interrupt timer RI timer

* Windowed watchdog timer

* Ultra-low power Real-Time Clock RTC on separate power domain

* Alarm timer; can be battery powered

* One 10-bit DAC with DMA support and a data conversion rate of 400 kSamples/s

* Two 10-bit ADCs with DMA support and a data conversion rate of 400 kSamples/s

* Hardware-based AES security engine programmable through an on-chip API

* Two 128-bit secure OTP memories for AES key storage and customer use

* Unique ID for each device

* Single 3.3 V 2.2 V to 3.6 V power supply with on-chip voltage regulator

* RTC power domain can be powered separately by a 3 V battery supply

* Four reduced power modes

* Overdrive mode to increase CPU and bus clock frequency

* Processor wake-up from Sleep mode via wake-up interrupts

* Wake-up from Deep-sleep, Power-down, and Deep power-down modes

* Brownout detect with four separate thresholds for interrupt and forced reset

* Power-On Reset POR

## Target Applications

* Industrial

* Consumer

* White goods

* RFID readers

* e-Metering

## Features