MAX3222E

具有 +/-15kV ESD 保护的 3V 至 5V 多通道 RS-232 线路驱动器/接收器

The consists of two line drivers, two line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin serial-port connection pins, including GND.

The device meets the requirements of A/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. The device operates at typical data signaling rates up to 500 kbit/s and a maximum of 30-V/µs driver output slew rate.

The MAX3222E can be placed in the power-down mode by setting the power-down PWRDOWN input low, which draws only 1 µA from the power supply. When the device is powered down, the receivers remain active while the drivers are placed in the high-impedance state. Also, during power down, the onboard charge pump is disabled; V+ is lowered to VCC, and V– is raised toward GND. Receiver outputs also can be placed in the high-impedance state by setting enable EN high.

.

ESD Protection for RS-232 Bus Pins

.

±15-kV Human-Body Model HBM

.

±8-kV IEC61000-4-2, Contact Discharge

.

±15-kV IEC61000-4-2, Air-Gap Discharge

.

Meets or Exceeds the Requirements of

TIA/EIA-232-F and ITU v.28 Standards

.

Operates With 3-V to 5.5-V VCC Supply

.

Operates up to 500 kbit/s

.

Two Drivers and Two Receivers

.

Low Standby Current . . . 1 µA Typ

.

External Capacitors . . . 4 × 0.1 µF

.

Accepts 5-V Logic Input With 3.3-V Supply

.

Alternative High-Speed Pin-Compatible Device 1 Mbit/s for SNx5C3222E

.

APPLICATIONS

.

Battery-Powered Systems

.

PDAs

.

Notebooks

.

Laptops

.

Palmtop PCs

.

Hand-Held Equipment