AMIS30521C5212RG

两相步进电机驱动器

Introduction

The AMIS−30521/NCV70521 is a micro−stepping stepper motor driver for bipolar stepper motors. The chip is connected through I/O pins and a SPI interface with an external microcontroller. The AMIS−30521/NCV70521 contains a current−translation table. It takes the next micro−step depending on the clock signal on the “NXT” input pin and the status of the “DIR” = direction register or input pin. The chip provides a so−called “Speed and Load Angle” output. This allows the creation of stall detection algorithms and control loops based on load−angle to adjust torque and speed. It is using a proprietary PWM algorithm for reliable current control.

Features

• Dual H−Bridge for 2 Phase Stepper Motors

• Programmable Peak−Current Up to 1.2 A Continuous 1.5 A Short Time, Using a 5−Bit Current DAC

• On−Chip Current Translator

• SPI Interface

• Speed and Load−Angle Output

• 7 Step Modes from Full Step−up to 32 Micro−Steps

• Fully Integrated Current−Sense

• PWM Current Control with Automatic Selection of Fast and Slow Decay

• Low EMC PWM with Selectable Voltage Slopes

• Active Flyback Diodes

• Full Output Protection and Diagnosis

• Thermal Warning and Shutdown

• Digital IO’s Compatible with 5 V and 3.3 V Microcontrollers

• NCV Prefix for Automotive and Other Applications Requiring Site and Control Changes

• These are Pb−Free Devices

.