FTDI FT234XD-R 接口桥接器, USB 到 UART, 2.97 V, 5.5 V, DFN, 12 引脚, -40 °C
The is an USB2.0 Full Speed IC, offers a basic UART to USB bridge. The device is an UART, capable of operating up to 3Mbaud, with low power consumption 8mA. The FT234XD-R includes the complete FT-X series feature set, including battery charging detection and enables USB to be added into a system design quickly and easily over a UART interface.
-
.
-
Single Chip USB to Asynchronous Serial Data Transfer Interface
-
.
-
Entire USB Protocol Handled on Chip, No USB Specific Firmware Programming Required
-
.
-
Fully Integrated 2048-byte EEPROM for Storing Device Descriptors and CBUS I/O Configuration
-
.
-
Fully Integrated Clock Generation with no external crystal required + Optional clock o/p selection
-
.
-
Data Transfer Rates from 300 Baud to 3Mbaud
-
.
-
512-byte Transmit and Receive Buffer utilising buffer smoothing technology for high data throughput
-
.
-
Royalty-free VCP and Direct D2XX drivers eliminate requirement for USB driver development
-
.
-
Configurable CBUS I/O Pins
-
.
-
Transmit and Receive LED Drive Signals
-
.
-
UART Interface Support for 7 or 8 Data Bits, 1 or 2 Stop Bits and Odd/Even/Mark/Space/No Parity
-
.
-
Synchronous and Asynchronous Bit Bang Interface Options with RD# and WR# Strobes
-
.
-
Battery Charger Detection, presence of a charger on USB port to enable faster charging of Batteries
-
.
-
Device Supplied Pre-programmed with Unique USB Serial Number
-
.
-
Supports Bus Powered, Self-powered and High-power Bus Powered USB Configurations
-
.
-
Integrated +3.3V Level Converter for USB I/O
-
.
-
True 3.3V CMOS drive output and TTL input Operates down to 1V8 with external pull up
-
.
-
Configurable I/O Pin Output Drive Strength
-
.
-
Integrated Power-on-reset Circuit
-
.
-
UART Signal Inversion Option
-
.
-
Internal 3.3/1.8V LDO Regulators
Absolute maximum ratings for devices are as mentioned, accordance with the Absolute Maximum Rating System IEC 60134, exceeding these may cause permanent damage to the device.