MCB1200U

KEIL MCB1200U Evaluation Kit, Cortex-M0 MCU, PIO Port Access, ULINK2 debug Adapter

is a Keil MCB1200 evaluation board with ULINK2 debug adapter. Board enables to create and test working programs based on NXP LPC1200 family of ARM Cortex-M0 processor based devices. Board provides MCU pin access to many of the PIO port pins, 3.3VDC and ground. The NXP LPC1227FBD64/301 MCU provided with the MCB1200 board is a Cortex-M0 device with advanced ADC and Serial I/O capabilities. This device includes a serial wire debug interface for downloading and debugging. The device does not support a JTAG interface. A 12MHz crystal provides the clock signal for the CPU. The Cortex debug connector provides support for SWD feature of the Cortex-M0 device allowing application programming and debugging of on chip and off chip flash devices. Board connects the on chip serial UART to ST3232 which converts the logic signals to RS232 voltage levels. ULINK2 debug adapter connects PC"s USB port to target system and allows to program and debug embedded programs on target hardware.

.

33MHz LPC1227FBD64/301 device ARM Cortex-M0 processor based MCU in 64 pin LQFP

.

On chip memory of 128KB flash and 8KB RAM

.

Serial interface

.

Potentiometer for ADC input

.

Up to 55 GPIO

.

8 user LEDs + power

.

4 push buttons 2 GPIO, ISP, & reset

.

Power via USB connector

.

10 pin Cortex debug interface connector

Do not attach additional power supplies such as batteries while the USB supplies power to the MCB1200. This may harm PC.