L5964Q-V0Y

Monolithic dual 3.5A step-down switching regulator with LDO

L5964 is a dual step-down switching regulator with internal power switches and a low drop-out linear/standby regulator. All the regulators have independent supply voltages, enables, power goods and thermal protections.

The switching regulators have selectable voltage supervisors and power goods, and selectable current limits. The LDO has power good and fixed current limitation.

The two DC-DC converters can work in free-run condition, with frequency selectable between two values, 250 kHz or 2 MHz, or synchronize themselves to an external clock SYNCIN pin. They are 180° out of phase, while the synchronization output signal SYNCOUT pin is 90° out of phase with the first regulator. The phase shift simplifies the use of two ICs in the same application 4 DC/DCs regulators.

The high operating frequency allowed by the synchronization input helps to reduce AM and FM interferences and grants the use of small and low cost inductors and capacitors.

The two switching regulators can be used in parallel and increase the output current capability up to 7 A.

The L5964 can manage the microcontroller supply. A configurable reset output and a configurable watchdog input are available.

This IC finds application in the automotive segment, where load dump protection and wide input voltage range are mandatory. The total quiescent current, when both DC/DCs and LDO are disabled, is less than 10 μA.

The product is available in two different packages. A slug down package, QFN48, able to dissipate on the PCB. An exposed pad up package, LQFP64, when the power requirement is higher and an external heatsink is needed.

**Key Features**

.

AEC-Q100 qualified

.

Two step-down synchronous switching voltage regulators with internal power switches:

.

Wide operating input voltage range from 3.3 V to 26 V

.

Output voltage selectable by external divider feedback voltage at 0.9 V

.

0.9 V minimum output, maximum output limited by maximum Duty Cycle

.

DC/DCs can work in Low Power Mode for reduced current consumption in low output Load

.

Internal high-side/ low-side NDMOS

.

250 kHz and 2 MHz selectable free-run frequencies

.

250 kHz < f < 2.3 MHz synchronization range at SYNCIN pin

.

Programmable current limits at 2 A and 4 A

.

Independent hardware high voltage enabling pins

.

Independent supply inputs

.

180° phase shift, synch out is 90° out of phase with DC/DC1

.

Programmable switching frequency divider by 1, 2, 4, 8 between the two regulators

.

The two regulators can be paralleled

.

Independent voltage supervisors/power-goods with selectable thresholds through external pin:

.

two available thresholds for UV/OV/PG signals: 90-120-95% or 80-110-85% output voltage percentage

.

Soft-start, thermal protection

.

One standby/linear regulator:

.

Output selectable with external resistor divider till 10 V

.

Soft start, hardware enable pin

.

250 mA maximum current capability

.

Standby operative mode

.

Programmable power good thresholds 85% or 95% output voltage percentage

.

Thermal protection

.

Microcontroller reset with programmable duration, activated by output under voltage or watchdog fault

.

External High Side Driver enable pin

.

One integrated window watchdog 5 ms ≤ window ≤ 50 ms, with ± 20% tolerance

.

Short circuit protected outputs

.

Low external components number

.

Low EMI

.

Automotive qualified - AECQ 100 -40 to 105°C

.

Thermal shutdown junction temperature 150°C