EJ1N-TC2A-CNB

CelciuX° Basic Unit - ScrewlessUp to 64 units can be connected when configured using Basic Units EJ1N-TC4/TC2 only Distributed placement is possible by using End Units stock no. 561-653 Up to 16 units may be connected side-by-side not including End Units. ### 注Supply voltage and communication functions RS-485, port A or B are available from the End Unit EJ1C-EDU, stock no. 561-653. An End Unit is always required for connection to a Basic Unit or an HFU. An HFU cannot operate without a Basic Unit. External communications cannot be performed when using a Basic Unit only. Refer to manufacturer"s data sheet for further information.### 注意When used with the HFU, the Basic Unit must be connected to the left side.### Omron CelciuX### Omron CelciuX°Modular multi-channel temperature controller that interfaces with a wide range of industrial networks Program-less communication with Omron and non-Omron PLC"s and HMI"s Capable of handling complex temperature profiles using Omron"s Gradient Temperature Control GTC algorithm Up to 16 temperature control units may be added to create a system Multiple end units may be added to expand up to 250 loops Configuration using CX-Thermo - a component of CX-One/CX-One Lite ### 注A certain amount of time is required for the outputs to turn ON from the time the power supply is turned ON. Due consideration must be given to this time when incorporating Temperature Controllers in a sequence circuit. It takes 30 minutes from the time the Temperature Controller is turned ON until the current temperature is displayed. Always turns ON the power supply at least 30 minutes before starting temperature control. Avoid using the Temperature Controller near a radio, television, or other wireless device. Its use would result in reception disturbance.

CelciuX° Basic Unit - Screwless

Up to 64 units can be connected when configured using Basic Units EJ1N-TC4/TC2 only

Distributed placement is possible by using End Units stock no. 561-653

Up to 16 units may be connected side-by-side not including End Units.

### 注

Supply voltage and communication functions RS-485, port A or B are available from the End Unit EJ1C-EDU, stock no. 561-653. An End Unit is always required for connection to a Basic Unit or an HFU. An HFU cannot operate without a Basic Unit. External communications cannot be performed when using a

Basic Unit only. Refer to manufacturer"s data sheet for further information.

### 注意

When used with the HFU, the Basic Unit must be connected to the left side.

### CelciuX°

Modular multi-channel temperature controller that interfaces with a wide range of industrial networks

Program-less communication with Omron and non-Omron PLC"s and HMI"s

Capable of handling complex temperature profiles using Omron"s Gradient Temperature Control GTC algorithm

Up to 16 temperature control units may be added to create a system

Multiple end units may be added to expand up to 250 loops

Configuration using CX-Thermo - a component of CX-One/CX-One Lite

### 注

A certain amount of time is required for the outputs to turn ON from the time the power supply is turned ON. Due consideration must be given to this time when incorporating Temperature Controllers in a sequence circuit. It takes 30 minutes from the time the Temperature Controller is turned ON until the current temperature is displayed. Always turns ON the power supply at least 30 minutes before starting temperature control. Avoid using the Temperature Controller near a radio, television, or other wireless device. Its use would result in reception disturbance.