ST62T62CM3

8位OTP / EPROM微控制器与A / D转换器，国家外汇管理局复位，自动重装定时器和EEPROM 8-BIT OTP/EPROM MCUs WITH A/D CONVERTER, SAFE RESET, AUTO-RELOAD TIMER AND EEPROM

GENERAL DESCRIPTION

INTRODUCTION

The ST62T52C and ST62T62C devices is low cost members of the ST62xx 8-bit HCMOS family of microcontrollers, which is targeted at low to medium complexity applications. All ST62xx devices are based on a building block approach: a common core is surrounded by a number of on-chip peripherals.

The ST62E62C is the erasable EPROM version of the ST62T62C device, which may be used to emulate the ST62T52C and ST62T62C devices as well as the ST6252C and ST6262B ROM devices.

■ 3.0 to 6.0V Supply Operating Range

■ 8 MHz Maximum Clock Frequency

■ -40 to +125°C Operating Temperature Range

■ Run, Wait and Stop Modes

■ 5 Interrupt Vectors

■ Look-up Table capability in Program Memory

■ Data Storage in Program Memory: User selectable size

■ Data RAM: 128 bytes

■ Data EEPROM: 64 bytes none on ST62T52C

■ User Programmable Options

■ 9 I/O pins, fully programmable as:

   – Input with pull-up resistor

   – Input without pull-up resistor

   – Input with interrupt generation

   – Open-drain or push-pull output

   – Analog Input

■ 5 I/O lines can sink up to 30mA to drive LEDs or TRIACs directly

■ 8-bit Timer/Counter with 7-bit programmable prescaler

■ 8-bit Auto-reload Timer with 7-bit programmable prescaler AR Timer

■ Digital Watchdog

■ Oscillator Safe Guard

■ Low Voltage Detector for Safe Reset

■ 8-bit A/D Converter with 4 analog inputs

■ On-chip Clockoscillator can be driven by Quartz Crystal Ceramic resonator or RC network

■ User configurable Power-on Reset

■ One external Non-Maskable Interrupt

■ ST626x-EMU2 Emulation and Development System connects to an MS-DOS PC via a parallel port