UCC28070EVM

TEXAS INSTRUMENTS  UCC28070EVM  评估板, UCC28070 300W PFC预调节器

The is an evaluation module for UCC28070 300W, two phase interleaved, power factor correction pre regulator that uses average current mode control techniques to achieve near unity power factor. The pre regulator was designed to operate off a universal ac line input of 85V to 265V and provides a regulated 390V dc output. The UCC28070 is an advanced power factor correction device that integrates two pulse width modulators operating 180° out of phase. This interleaved PWM operation generates substantial reduction in the input and output ripple currents, and the conducted EMI filtering becomes easier and less expensive. A significantly improved multiplier design provides a shared current reference to two independent current amplifiers that ensures matched average current mode control in both PWM outputs while maintaining a stable, low distortion sinusoidal input line current.

.

Inter leaved average current mode PWM control with inherent current matching

.

Advanced current synthesiser current sensing for superior efficiency

.

Programmable frequency 30KHz to 300KHz

.

Programmable maximum duty cycle clamp

.

External clock synchronization capability

.

Programmable peak current limiting

.

Bias supply UVLO, over voltage protection, open loop detection, and PFC enable monitoring

.

External PFC disable interface

There are high voltages present on the pre regulator and it should only be handled by experienced power supply professionals.