MC10EL89DR2G

5V ECL同轴电缆驱动器 5V ECL Coaxial Cable Driver

The MC10EL/100EL89 is a differential fanout gate specifically designed to drive coaxial cables. The device is especially useful in Digital Video Broadcasting applications; for this application, since the system is polarity free, each output can be used as an idependent driver. The driver boasts a gain of approximately 40 and produces output swings twice as large as a standard ECL output. When driving a coaxial cable, proper termination is required at both ends of the line to minimize signal loss. The 1.6V output swings allow for termination at both ends of the cable, while maintaining the required 800mV swing at the receiving end of the cable. Because of the larger output swings, the device cannot be terminated into the standard -2.0V. All of the DC parameters are tested with a 50 Ω to -3.0V load. The driver accepts a standard differential ECL input and can run off of the Digital Video Broadcast standard -5.0V supply.

Features

---

 |

.

375ps Propagation Delay

.

1.6V Output Swings

.

ESD Protection: >1 KV HBM, >100 V MM

.

PECL Mode Operating Range: VCC= 4.2 V to 5.7 V with VEE= 0 V

.

NECL Mode Operating Range: VCC= 0 V with VEE= -4.2 V to -5.7 V

.

Internal Input Pulldown Resistors

.

Meets or Exceeds JEDEC Spec EIA/JESD78 IC Latchup Test

.

Moisture Sensitivity Level 1

For Additional Information, see Application Note AND8003/D

.

Flammability Rating: UL-94 code V-0 @ 1/8",Oxygen Index 28 to 34

.

Transistor Count = 31 devices

.

Pb-Free Packages are Available